|
Hardware Specifications
|
|
Models:
|
iSCSI IP Storage 2u12/3000
iSCSI IP Storage 2u12/4800
iSCSI IP Storage 2u12/6000
iSCSI IP Storage 2u12/9000
|
|
Raw Storage Capacity
|
Expandable to 3.0 TB - using twelve 250 GB drives
Expandable to 4.8 TB - using twelve 400 GB drives
Expandable to 6.0 TB - using twelve 500 GB drives
Expandable to 9.0 TB - using twelve 750 GB drives
|
|
Drive Bays
|
12 Serial ATA (SATA) Hot Pluggable
|
|
Hard Disk Drive Supported
|
3.5" SATA
|
|
Processor
|
A single Intel® Xeon® processor 2.80 GHz with 1 MB L2 cache
|
|
Memory Capacity
|
2GB expandable to 16GB maximum
|
|
Memory Type
|
Synchronous Dynamic Random Access Memory (SDRAM), DDR2-400, Registered, ECC
|
|
DIMM Slots
|
Six 184-pin DIMM sockets
|
|
Enclosure Management Controller
|
On-board Vitesse* VSC055 micro-controller
|
|
Temperature Sensor
|
Two temperature sensors are located on the backplane that allows drive cage temperature monitoring by enclosure management
|
|
SAF-TE Support
|
The backplane firmware complies with version 1.00 rev 041497, of the SAF-TE specification
|
|
SATA Compliance
|
SATA 1.5 Gb/s, 3.0 Gb/s
|
|
Client Connectivity
|
Client connectivity via Internet Protocol Small Computer System Interface (iSCSI) Dual Gb/s Ethernet Quad Gigabit Optional
|
|
Serial Port
|
Management console port
|
|
Front Panel
|
|
LEDs
|
Fault, ID, Power
|
|
Back Panel
|
|
Buttons and Switches
|
Power button, Reset button
|
|
I/O Connectors
|
1x RJ-45 COM B Serial port, 2x RJ-45 Ethernet ports
|
|
Power Receptacle
|
1x IEC AC per installed power supply module
|
|
Chassis
|
|
Form Factor
|
2U rack-mount chassis
|
|
Height
|
86.7 mm, 3.41"
|
|
Width
|
447 mm, 17.6"
|
|
Depth
|
631 mm, 24.8"
|
|
Color
|
Black plastics, Silver sheet metal
|
|
Rack Support
|
As shipped (zero drives): approximately 16 kg, 35.2 pounds
Fully configured (twelve drives): approximately 27.5 kg, 61 pounds
Shipping container: 3.2 kg, 7 pounds
|
|
System Cooling
|
|
Fans
|
Chassis includes three dual rotors and two single rotor 40 mm hot-swappable redundant system fans for cooling the hard drives, baseboard and SATA Host Bus Adapter (HBA) cards
The Power supply enclosure contains one 60 mm fan
|
|
Power
|
|
Configuration
|
500 W continuous, 1+1 redundant power supplies
|
|
Max AC input current (PS Module)
|
7.2 Amperes at 110 Vrms, 3.5 A at 220 Vrms (each power supply module)
|
|
Max +3.3 V output (PS Enclosure)
|
20.0 A (total combined power for the +3.3 V and +5 V outputs should not exceed 120 W)
|
|
Max +5 V output (PS Enclosure)
|
20.0 A (total combined power for the +3.3 V and +5 V outputs should not exceed 120 W)
|
|
Max +12 V output1 current (PS Module)
|
18.0 A (total combined power for the +12 V outputs should not exceed 360 W)
|
|
Max +12 V output2 current (PS Module)
|
18.0 A (total combined power for the +12 V outputs should not exceed 360 W)
|
|
Max +12 V output3 current (PS Module)
|
18.0 A (total combined power for the +12 V outputs should not exceed 360 W)
|
|
Max -12 V output current (PS Module)
|
0.5 A (each power supply module)
|
|
Environment
|
|
Ambient Temperature
|
Operating (system): 10° C to +35° C, with maximum change not to exceed 10° C; non-operating (system): -40° C to +70° C
|
|
Relative Humidity
|
Non-operating: 90% @ 35° C non-condensing
|
|
Acoustics
|
<59 decibel average (dBA) (rack mount) in an idle state in a normal office environment (23° C)
|
|
Electrostatic Discharge
|
15 KV per Intel test specification
|
|
Safety Compliance
|
|
Argentina
|
IRAM
|
|
Canada
|
UL60950 – CSA 60950 (UL and cUL)
|
|
Europe, CE Mark
|
EN60950 (complies with 73/23/EEC)
|
|
Germany
|
GS License
|
|
International
|
IEC60950 (CB Report and Certificate)
|
|
Nordic Countries
|
EMKO–TSE (74-SEC) 207/94
|
|
Russia
|
GOST 50377-92
|
|
United States
|
UL – 60950 – CSA 60950 (UL and cUL)
|
|
China
|
GB4943 – CNCA Certification
|
|
Australia/New Zealand
|
AS/NZS 3548 (based on CISPR 22)
|
|
Electromagnetic Capability (Class A) (EMC)
|
|
Canada
|
ICES-003
|
|
Europe, CE Mark
|
EN55022; EN55024 & EN61000-3-2;-3-3 (complies with 89/336/EEC)
|
|
International
|
CISPR 22
|
|
Japan
|
VCCI
|
|
Korea
|
RRL, MIC 1997-41 and 1997-42
|
|
Russia
|
GOST 29216-91 and 50628-95
|
|
Taiwan
|
CNS13438
|
|
United States
|
FCC, Part 15
|
|
China
|
GB 9254 - CNCA Certification
GB 17625 - (Harmonics) CNCA Certification
|
IP SAN systems, such as the iSCSI IP storage 2u12, use the emerging iSCSI standard for data transport over existing Ethernet infrastructures. With industry-standard hardware architectures and simple new SAN management tools to further lower the cost of SAN systems, IP SAN's are now within reach of most companies. Featuring a single Intel® Xeon® processor, support for up to 12 Serial ATA (SATA 300) hard drives, iSCSI or optional Fibre Channel connectivity and intuitive SAN management tools, the iSCSI IP storage 2u12 provides easy management of storage resources. It also has the built-in headroom to accommodate an IT administrator's rapidly growing storage needs.